So I bought this after another reviewer stated it fit their MYM #32. Luckily I’m handy because I can confirm it does not fit. The problem is the auger stud adapter, it’s a 1/16” wider than MYM stud. You have to remove that material in order to get it to fit down into the recess where the stud adapter screws into the MYM auger. This is necessary or your plates won’t sit deep enough into the grinder head to catch the plate notches and then your plates may spin while grinding. Was easy to do if you have tools and know how.Edit 11-12-24: something else that is a must, you will need two 18 gauge machine bushing washers (1 3/8 OD x 7/8 ID) to go behind the nylon washer on back of auger. Without these spacers when you screw the grinder head nut on there won’t be enough tension on your grinding plates. Can confirm after these two modifications this setup does indeed work and I’m happy with it so farEdit 2-26-25Well the above edit was true the two shims do push the plate farther out the front of the head so when you screw the nut on the front it can put some more tension on the plate but this created another issue. The first kidney shaped plate is now not engaging the plate pin enough and can jump out and over the pin which causes this plate to spin freely while grinding and now you have mushy burger. I found another work around to make this setup work but I would strongly discourage anyone from using this on a MYM grinder unless they really wanna tinker with this thing to get it dialed in